I have a cisco 1941 ISR router and I am trying to configure a router to allow a modem for Offband or Out of band access.
Below is the configuration on Aux port on Line (n):
line aux 0
login local
modem InOut
transport input all
speed 115200
flowcontrol hardware
I have US Robotics 56k Faxmodem which is connected to aux port of router and I am using USB dialup modem with my laptop to dailin to the router which is connected to a US Robotics Faxmodem. Then I have accessed my USB dialup modem throught HyperTerminal and I can issue all at commands and to dialin to the modem I have used the following command
atdt914011111111 (atdt followed by country code, area code and landline number)
Once I issue the above command it give me message Connected and after this I just get a flashing cursor. I cannot do anything nor will it display a username login prompt.
Below is the configuration on Aux port on Line (n):
line aux 0
login local
modem InOut
transport input all
speed 115200
flowcontrol hardware
I have US Robotics 56k Faxmodem which is connected to aux port of router and I am using USB dialup modem with my laptop to dailin to the router which is connected to a US Robotics Faxmodem. Then I have accessed my USB dialup modem throught HyperTerminal and I can issue all at commands and to dialin to the modem I have used the following command
atdt914011111111 (atdt followed by country code, area code and landline number)
Once I issue the above command it give me message Connected and after this I just get a flashing cursor. I cannot do anything nor will it display a username login prompt.